Overview Shelly LinkedGo thermostat

The LinkedGo ST1820 is a room thermostat for underfloor heating labelled "powered by Shelly". It measures room temperature and humidity and switches the actuators of the underfloor heating via a relay. A dry contact can additionally enable a heat source. The control loop runs in the thermostat itself: the block sets the setpoint and operating mode and reads back the measured values.

The thermostat connects to the MQTT broker of the controller via Wi-Fi. In the web interface of the thermostat, under Settings - MQTT, enable MQTT, enter the address of the controller as server and switch on RPC status notifications over MQTT. The topic shown there (MQTT prefix) is entered in the block as parameter.

If the setpoint or operating mode is changed on the knob or in the Shelly app, the block also writes the new value to the address on the corresponding input. The visualisation therefore always shows the state of the device.

Hysteresis, temperature and humidity offset, anti-freeze temperature and the permitted setpoint range are set in the web interface of the thermostat. The thermostat does not report whether the relay is currently heating.

Inputs

EN On/Off Switches the control of the thermostat on (1) or off (0). When switched off, the thermostat does not heat.
ST Setpoint temperature Setpoint for the room temperature in °C. The thermostat accepts values within the range set in the device, 5 to 30 °C by default.
FS Anti-freeze Switches the anti-freeze protection on (1) or off (0). The thermostat then keeps at least the anti-freeze temperature set in the device.
KS Child lock Locks (1) or unlocks (0) operation on the device.

Outputs

RT Room temperature Room temperature measured by the thermostat in °C.
RH Humidity in % Relative humidity measured by the thermostat.
EN Status on/off Feedback whether the control is switched on.
ST Setpoint temperature status Feedback of the setpoint set in the thermostat.
FS Status anti-freeze Feedback whether anti-freeze protection is switched on.
KS Status child lock Feedback whether the child lock is active.

Parameters


MQTT topic Topic of the thermostat as shown in the MQTT settings of the device. Example: shellyxt1-AABBCCDDEEFF
The command generate addresses creates addresses for on/off, setpoint temperature, room temperature and humidity. In addition, it creates an address named timeout. It is set to 1 when the device has not sent a message for a longer period of time.

See also MQTT devices - general.
See also general parameters of all function blocks.