Constant light control

With this function block a constant light control is implemented.

Inputs
BA	Operating mode*	Operating mode: 0=Automatic 1=On 2=Off
IW	Actual value*	Actual value brightness
SW	Setpoint*	Setpoint brightness
Outputs
A1-Ax	Outputs	Outputs
Parameters
	Number of outputs	Number of outputs
	Gain P	Gain of the PI controller. The higher the value, the faster the control.
	Reset time I	Reset time, time over which the deviation is accumulated.
	Hysteresis	Hysteresis for setpoint/actual value comparison (acts in both directions).
	Initial value	Output value with which the control is started. From this value the control then proceeds plus or minus.

Inputs