PV load

With this function block, consumers can be switched on and off depending on the PV surplus.

Inputs
BA	Operating mode	Operating mode: 0=Automatic 1=On 2=Off
PU	Surplus*	PV surplus. Whether surplus is positive or negative can be set via the parameter Type surplus.
FG	Enable	Optional enable. If input is 1, control is enabled. This input can be used to switch the control on and off in automatic mode without having to change the operating mode. If the input is not connected, the control is always enabled.

Outputs
A1-AX		Outputs for load

Parameters
	Number of outputs	Number of outputs
	Time switch on/off	Time over which switching on/off is performed.
	Minimum surplus	Minimum surplus that must at least be present for the control to begin.
	Consumer	Here a consumption value can be specified for each consumer. The output is switched on when the surplus exceeds this value.
	Type surplus	Surplus positive: a positive value at the input means surplus. Surplus negative: a negative value at the input means surplus.

Inputs