Overview Philips Hue


With this function block, lamps can be controlled via a Philips Hue bridge.



Inputs

EI
 On
HE
 Brightness
RGB Red,Green,Blue

Outputs
SE
 On status
SH
 Brightness status
RGB Status Red,Green,Blue

Parameters
Bridge user ID
 User ID. This can be created via the search function.

  1. Enter the IP address for the Hue bridge.
  2. Save the project permanently to the controller.
  3. After a short waiting time of approx. 10 seconds, activate the pairing via the search function using the key symbol.
  4. The user ID is then entered at the function block.
  5. This only has to be done once; the same user ID can then be copied to all function blocks.

However, this does not yet work with all Hue bridges. If an error occurs, it must be created manually. See the following link:

https://developers.meethue.com/develop/get-started-2/
Bridge IP address
 IP address of the Hue bridge
Luminaire ID
 ID of the luminaire. This can be determined via the search function.

  1. Enter the user ID and the IP address for the Hue bridge.
  2. Create a boot project.
  3. After a short waiting time of approx. 10 seconds, you can search for devices via the search function.

See also common parameters of all function blocks.