MBUS

This function block can be used to read out M-BUS devices. An RS232-M.BUS gateway is required for this.

Outputs
W0-X	Meter values	Measured value read out.
Parameters
	Read type	Single frame or multiframe.
	Addressing	Addressing via primary address or secondary address.
	ID/serial number	ID for primary address or serial number for secondary addressing.
	Read interval	Interval in seconds. Please note that some meters temporarily do not respond if read out too frequently.
	Interface	Interface selection
	Data	Configuration of the data / outputs. Normally not all data of the meter is always needed, therefore the data can be selected. The dialog has two fields, on the left a list of the configured values, on the right the data fields that were read out from the meter. If the controller is connected to the gateway, the button "Read query" can be used to read out the meter. In the right window all data is displayed. With the button between the windows (left arrow) the data on the right side can now be transferred to the left side. Only for the data on the left side are variables also generated and connected to the outputs. Optionally the data can also be created manually via the toolbar buttons +/-. For this you need to know the position within the data.

Outputs