Overview Shelly Plus Smoke

The Shelly Plus Smoke is a battery-powered smoke detector. If the device reports an alarm, the corresponding output stays set until it is reset via the reset input. This way an alarm remains visible even if it has already disappeared at the device.

Inputs
RS Reset On every change from 0 to 1 the alarm and alarm test outputs are reset.

Outputs
AL Alarm Is set to 1 when the device reports smoke. Stays set until reset.
AT Alarm test Is set to 1 when the test button was pressed at the device. Stays set until reset.
BP Battery % State of charge of the battery in percent.
BA Battery alarm Is set to 1 as soon as the battery level is 10 % or less.

Parameters

MQTT topic Topic of the device, exactly as in the MQTT settings of the device. Example: shellyplussmoke-AABBCCDDEEFF
In addition to the outputs listed, the command generate addresses creates an address named timeout. It is set to 1 when the device has not sent a message for a longer period of time.

See also MQTT devices - general.
See also general parameters of all function blocks.