Pulse width modulator

This function block generates a pulse-width-modulated signal at the output (PWM signal).

Inputs
FG	Enable	Enable. With 1 at the input the PWM signal is output. This input is optional; if this input is not connected, the block is always enabled.
PW	Pulse width [%]	Pulse width in percent. Specifies the on-time as a percentage; this is calculated from the parameter PWM pulse time. A value of 50% and a PWM pulse time of 60 seconds results in an on-time of 30 seconds and an off-time of 30 seconds.
Outputs
PI	PWM pulse	PWM signal
PZ	Pulse time	Time until the next pulse change
Parameters
	PWM pulse time	Pulse time in seconds
	Percent minimum	Limit of the percent input minimum.
	Percent maximum	Limit of the percent input maximum.

Inputs