KNX Gate switch
KNX Gate switch| With
this
function block, the assignment of one KNX variable to another can
be controlled or telegrams can be pass/blocked. Only if the Enable
is
set to 1, the telegrams at the input are sent to the output. This
can
be used, for example, for a simple partition wall control. Important: This function block is only intended for KNX bus addresses at the output. It is not possible to link further function blocks at the output. |
Inputs |
||
| E1 |
Variable |
A variable must be connected to the
input. |
| FG |
Enable |
The telegrams are only forwarded to
the output if this input 1 is present. |
Outputs |
||
| A1 |
Variable |
A variable must be connected to the output. |
Parameter |
||
| Set
an output at FG. |
With
this parameter a telegram with the value of the input is sent at
Enable
1, otherwise only when the first telegram is received. |
|