Block Motion Detector

Block function block for the control element Block Motion Detector; the control element must be connected to this function block. See Block Presence and Presence General.

Inputs
TR	Trigger	Motion detector
HE	Brightness	Brightness optional. Optionally, a brightness can be connected here in order to activate the motion detector only below a certain limit value.
BA	Operating mode	Operating mode optional. Optionally, an operating mode can be connected here. If the input is not connected, Automatic is always preset. 0 = Automatic, 1 = Permanently on, 2 = Permanently off.
Outputs
ST	Switch	Switch address
PT	Percent	Value address
SB	Status Bit	Status outputs, e.g. brightness reached; required for the connected control element for display. The status is bit-coded: Bit 0 = State_Enabled Bit 1 = State_Brighness_Ok Bit 2 = State_Trigger Bit 3 = State_Active
Parameters
	Trigger	Triggering of the motion detector with a rising edge or telegram.
	Retriggering	Consider brightness: If the detector is activated and the time is running, the brightness limit value is considered for retriggering. Ignore brightness: If the detector is activated and the time is running, on renewed activation the brightness is not considered.

Inputs